Filter
Top Products
Replacing
Burn, Electrical Shock and Fire Hazard
l
Make sure all surface units are OFF before replacing surface units and
reflector bowls. Failure to do so can result in burns or electrical shock.
l
Do not line the reflector bowls with foil. Fire or electrical shock
could result
1.
Turn off all surface units. 2. Line up openings in the reflector
bowl and notches in the trim ring
with the surface unit receptacle
and the element hold down clip.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, pus1
down the edge of the surface unl
opposite the receptacle. The ele-
ment hold down clip will keep th6
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on fhe surface
units. They also help catch spills. When they are kept clean, they reflect
heat better and look new longer.
If a trim ring gefs discolored, some of fhe utensils may not be flat
enough, or some may be too large for the surface unit. In either case,
some of the heat that’s meant to go info or around a utensil goes down
and heats the trim ring. This extra heat can discolor if. See Cooking
Guide for further information.