Filter
Top Products
If You Need Assistance
Or Service
Thls section is designed to help you save the cost of a service call. First we outline possible problems,
their causes and their solutions. However, you may still need assistance or service. When calling our
Consumer Assistance Center for help or calling for service, you will need to provide a complete descrip-
tion of the problem, your appliance’s complete
model and serial numbers
and the purchase date. (See
page 2.) This information is needed to respond to your request properly.
1. Before calling for assistance . . .
Performance problems often result from little things you can find and fix without tools of any kfnd. Please
check the chart below for problems you can fib. lt could save you the cost of a service call.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Nothing will The power cord is not plugged into Plug the power cord into a live circuit with
operate a live circuft with proper voltage. proper voltage. (See Installation Instructions.)
A household fuse has blown or a
Replace household fuse or reset circuit
circuit breaker has tripped. breaker.
The oven will
The Oven Selector is not turned to
Turn the Oven Selector to the desired
not operate BAKE or BROIL. setting.
A delayed start time has been set.
Wait for the start time to be reached.
The Oven Temperature Control
Knob is not turned to a tempera-
Turn the Oven Temperature Control Knob to
ture setting.
a temperature setting.
The automatic MEALTIMER” clock
Set the MEALTIMER clock correctly. (See
is not set correctly. “Using the automatic MEALTIMER” clock” on
page 16.)
The Stop or Start Time Knobs for lf a delay start or stop is not desired, the Stop
the automatic MEALTIMERTY
and Start Time Knobs must be turned to the
clock are not set at the correct time
correct time of day. Turn knobs till they pop
of day.
Out.
The surface
A household fuse has blown or a
Replace household fuse or reset circuit
unfts will not
circuit breaker has tripped. breaker.
operate
Surface units are not plugged in Plug surface units in all the way.
all the way.
(See “Replacing” on page 23.)
The control knobs are not being
Push control knobs in before turning to a
set correctly.
setting.
Control
You are not pushing in before
knob(s) will
Push control knob(s) in before turning to a
turning.
setting.
not turn
28