Filter
Top Products
Caring For Your Range
Continued
1. Lift the edge of the unit opposite the
receptacle, just enough to clear the
element hold down clip, reflector
bowl and trim ring.
2. Pull the surface unit straight away
from the receptacle.
3. Lift out the reflector bowl and trim
ring. See Cleaning tips” on page 25
for cleaning Instructions.
Replacing
Burn, Electrical Shock and
Fire Hazard
l
Make sure all surface units are
OFF before replacing surface
units and reflector bowls.
Failure to do so can result in
burns or electrical shock.
l
Do not line the reflector bowls
with foil. Fire or electrical shock
could result.
18
1. Line up openings in the reflector
bowl and notches In the trim ring with
the surface unrt receplacle and the
element hold down clip.
2. Hold the surface unit as level as pos-
sible wrth the terminal just started
into the receptacle. Push the surface
unit terminal into the receptacle.