Filter
Top Products
SURFACE
SIGNAL LIGHT
I
RIGHT’REAR
RIGHT’FRONT
CONTROL KNOB
CONTROL KNOB
Using the surface units
Surface Unit Indicators
.
Control knobs must be pushed in
. -
Detore turning them to a setting. They
can be set anywhere between 9
and OFF.
The solid dot in the surface unit
indicator shows which surface unit
is turned on by that knob.
Surface Signal light
The Surface Signal Light will be on
when a surface unit is ON.
Until you get used to the settings, use the following as a guide. For best results,
start cooking at the high settings; then turn the control knob down to continue
cooking.
Use HI to start Use MED-HI
Use MED Use MED-LO
Use LO to
foods cook-
to hold a
for gravy to keep food keep food
ing; to bring
rapid boil; to puddings
cooking after warm until
liquids to a
fry chicken
and icing; to
starting it ready to
boil.
or pancakes.
cook large on a higher
serve. Set the
amounts of
setting.
heat higher
vegetables
or lower
CAUTION: The use of the HI sefflng for llong perlods of ttme
can damage surface units and discolor chrome retlector
bowls. Start cooklng on HI and turn control down to con-