Whirlpool RGH 8300-1 Ventilation Hood User Manual


  Open as PDF
of 4
 
RANGE HOOD
BLOWER ORIENTATION
NOTE: Before reinstalling the Blower Assembly check the
c!zmper for free operation. Open the damper bla?e a?d check for
any restrictlons in the duct system. Check Instaliailon InstructIons
for proper duct sizing.
Correct Blower crientation is imperative Incorrec! installation
will drasticallv cut air flow and cause Blower IO run a! maximum
RPM regardless
Of
motor speed control
Seitlilg.
VERTICAL DISCHARGE:
1. Figure 1 shows the proper Blower Assembly
vertical discharge.
2. From tire Blower positlon shown in Figure 1
Assembly vertically Into mounting positton.
orientation for
lift the Blower
3. The 3” Blower discharge surface should’ now be flush against
top of hood. This will allow proper ai:flowfrom the alower through
the top ven:. (The wider 5” surface will be to the rear).
HORIZONTAL DISCHARGE:
1. Figure 2 shows the proper Blower Assembly orientation for
horizontal discharge.
2. From the Blower position shown In Figure 2, lift the Blower
Assembly vertically into positlon.
3. The 3” Blower discharge surface should now be flush against
rear
of hood. This wail aliow proper air f!ov: from the Blower
through the rear vent. (The wider 5’. surface WIII be to the top).
BLDWER DISCHPRZE -
~o’,&lE GT DIS-
CHARGE VENT IN
TOP OF HO30
FIGURE I
VERTICAL DISCHARGE
. ’
l
.
THIS
SURFACE
To TOP
aLowER
DISCHARGE-
LOCATE AT DtS-
CHARGE VENT
IN REAR 0~ HOCD
FIGURE 2
HORIZONTAL DISCHARGE
 previous