Filter
Top Products
This hood is designed to be compatable with Whirlpool
Eyelevel Ranges RHM, RM, RE, REE, RFE and
RGE, the power source for the hood is supplied direct-
ly from the range. See Section C.
Before starting . . .
To install the range hood read the following instructions
completely and carefully. There are important steps
outlined that will simplify the installation job when
followed carefully. In addition, they will help you decide
what materials you need for your installation.
You’ll need these tools:
a
l Drill, electric or ratchet
drive, with 1 %a” wood bit
(to drill an access hole in
the cabinet or kitchen wall
for the electrical power
line.)
l One common head screw-
driver (to secure hood
mounting screws to the
cabinet and hood sheet
metal parts).
l Pliers (for opening knock-
outs)
l Pencil, ruler and level for
marking cabinet locations.
l Saber saw or keyhole saw
for cutting the wall or
cabinet openings.
Caulking, metal snips, duct
tape, ducts (with elbow and
transition, if necessary) and
wall cap or roof cap, as
required.
1 ‘- ‘. ,I
.h- P..?
‘.,q:.-
A. Selecting the proper
venting system
This oven hood can be vented either vertically through
the roof, horizontally out the wall, or ductless. Select
the most practical method for your particular
installation.
Figure 1 shows the standard through the roof venting.
Figure 2 illustrates horizontal venting. Make wiring wall
cutouts and venting cutouts according to dimensions
given in Figure 3.
For ductless installation see Section D.
HOOD-
OVEN-
FIGURE 1
)F CAP
-3% x 10 DUCT
*DAMPER
HOOD--r
OVEN-
FIGURE 2
DAMPER
WALL CAP