Filter
Top Products
VENTED KlTCHEN.RANGii HOOD 1
FOR
120 V. OPERATION
YKifl 01
4a
I
KITCHEN
RANGE HOOD
MODEL
RH7330XL
READ AND SAVE THESE INSTRUCTIONS
Before you begin,
read the following instructions
completely and carefully. If followed, they will
simplify
the installation job.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
This unit can be vented vertically through upper cabinets or
horizontally through an outside wall. A typical vertical
installation is shown in Figure 3. A typical horizontal
installation is shown in Figure 4.
For the most efficient operation, the top of the hood should
be approximately 66 inches (167.6 cm) from the floor.
1. Make a template or transfer measurements shown in Fig.
1 to cabinets or wall.
i
WIRING KNOCKOUT
Figure 1
2. Cut holes to acconodate ventilating duct allowing ‘/4”
clearance on all 4 sides for back vent. Allow %” clearance
toward front for vertical vent. Allow %” on other 3 sides for
top vent.
3. Cut appropriate hole for electrical wiring.
4. Run wire through wall or cabinets according to National
ElectrIcal Code and applicable local codes. (DO NOT turn
power on until installation is complete.
TOOLS AND MATERIALS REQU
IRED
l
Drill, electric or ratchet drive, with 1-X” wood bit (to
drill an access hole in the cabinet or kitchen wall forthe
electric power line.)
l
One common head screwdriver (to secure hood
mounting screws to the cabinet and hood sheet metal
parts).
l
Pllers (for opening knockouts).
l
Pencil, ruler and level for marking cabinet locations.
l
Saber saw or keyhole saw for cutting the wall or cabinet
openings.
l
Caulking. metal snips. duct tape. ducts (with elbow and
transition If Ilecessary) and wall cap or roof cap, as
required.