Filter
Top Products
23
Saving Energy
Saving energy is important and helps you save money. This section gives you tips on the best
ways to save energy with your dishwasher.
Loading tips
• Wash full loads. Running a half-filled
dishwasher uses the same amount of
electricity and hot water as a fully loaded
machine.
• Load correctly for best washing results.
Incorrect loading may cause poor washing.
You will then need to rewash all or part
of load.
Cycle and option tips
• Use the Light cycle whenever possible.
The cycle uses less hot water and energy
than the Normal cycle.
• Run your dishwasher during off-peak hours.
The local utilities recommend that you
avoid using too much energy at certain
times of the day.
• Do not use the Hi-Temp Wash option if it
is not needed. When this option is off and
water entering the dishwasher is lower than
140°F (60°C), the cycle does not take
additional time to heat water during the main
wash. In some cases, loads may not dry as
well when using the Hi-Temp Wash option.
NOTE: Loads may not wash or dry as well
if the water temperature is too low. For
best dishwashing results, water must be
at least 120°F (49°C) as it enters the
dishwasher.
• Use the Air Dry option whenever possible.
Allow longer drying times (overnight). Use
a rinse agent to improve drying.
• Do not prerinse normally soiled dishes.
Select the correct cycle for the load and
use the recommended amount of detergent.
To check water temperature:
1. Run the hot water at the faucet closest
to your dishwasher. Let the
water run for at least 1 minute.
2. Hold a candy or meat thermometer in the
running stream of water. If
water temperature at the
faucet is below 120°F (49°C),
have a qualified person raise
the water heater’s thermostat
setting.