Filter
Top Products
Lighting standing pilots
(model SFOlOOSY)
To light range pilots:
1. Make sure all controls are turned off.
2. Remove the surface burner grates from the
cooktop. Remove the cooktop. (See ‘Remov-
able cooktop” on page 16.)
3. To light, hold a Iii match over the pilot light
located between the front and back burners.
The pilot flame should be %to % in (.6-l cm)
high.
4. tf the pilot flame needs adjustment, turn the
pilot adjustment screw on the manifold pipe.
5. Replace the cooktop and the grates before
using the surface burners.
To light oven burner pilot:
1. Make sure the Oven Temperature Control is
turned off.
2. Pull broiler drawer open. Broiler door will tilt
down when opened.
3. Remove broiler pan, grid and broiler carriage
(see “Removing the broiler carriage” on
page 16).
4. Hold a lit match over the oven burner pilot
located at the rear of the burner.
5. After the oven burner pilot is burning stead-
ily, check burner lighting by turning the Oven
Temperature Control to a temperature
above 140°F (60%). The burner will take
50-60 seconds to light.
6. Replace the broiler carriage, broiler pan and
grid.
7. Close broiler drawer all the way.
11