Filter
Top Products
Surface Burners
0 IO PO on 0 ,’
B
TYPICAL TOP BURNER FLAME
To remove the cooktop, follow the instructions on pagel3.
Wipe off surface burners with warm soapy water and a soft cloth after each
use.
Occasionally check surface burner flames for size and shape as shown. If
flames do not burn properly, you may need to remove the surface burners for
cleaning (see pagel7) or call a qualified technician for burner adjustments,
To adJust the HI and LO settings on the control knobs:
1.
Turn on the surface burners, then set the controls on LO.
2. Wlthout changing the burner settings,
remove the control knobs.
3. Firmly grasp the control stem and insert a small bladed screwdriver into
the end of the stem. Turn the screwdriver in either direction until the flame
height isYe in (.318 cm) or lower in size.
Flame must be large enough to
malntaln a STABLE FLAME on all burner ports.
NEVER ADJUST THE FLAME SIZE AT THE MEDIUM SETTING.
The Oven Door
sier to clean the oven.
Open the door to the first stop
position.
2. Hold the door at both sides and lift
off of hinges at bottom corners of
door.
3. To replace,
fit the bottom corners
of the door over the ends of the
hinges.
Push the door down evenly. The
door will close only when it is on
the hinges correctly.
14