Filter
Top Products
Removing the freezer shelves
The freezer shelves can be removed for easier
cleaning.
To remove the shelves:
1. Lift right side of shelf off supports.
2. Slide shelf out of shelf support holes.
3. Replace in reverse order.
Removing the freezer bin
For proper air movement, keep the freezer bin in
place when the refrigerator is operating.
To remove the bin:
1. Slide bin out to the stop.
2. Lift bin at the front to clear the stop.
3. Slide bin out the rest of the way.
To replace the bin:
1. Place bin on the slides.
2. Make sure the stops clear the front of the
slides.
3. Slide bin in.
Using the automatic ice maker
Here are a few things you will want to know
about your automatic ice maker:
l
The ON/OFF lever is a wire signal arm.
Down . . .
to make ice automatically.
Up . . . to shut off the ice maker.
NOTE: Do not turn ice maker on until
connected to the water suDDhr.lbstructlona
.
or Ice maker water supplv hook up are
hed to the back of the refriaerator
cabinet.
l
It is normal for ice crescents to be attached by
a corner. They will break apart easily.
l
The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
l
If ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control
toward a higher number. Wait a day and, if
necessary, turn the Freezer Control toward C.
l
Good water quality is important for good ice
quality. It is not recommended that the ice
maker be connected to a softened water
supply. Water softener chemicals, such as salt
from a maffunctioning softener, can damage
the ice maker mold and lead to poor quality ice.
If a softened water supply cannot be avoided, it
is important that the water softener be well
maintained and operating properly.
Raise
signal
arm to
stop ice
maker.
Lower
signal
arm to
start ice
maker.
10