Whirlpool TUD400 Dishwasher User Manual


 
17
Storing Your Dishwasher
Storing for the summer
Protect your dishwasher during the summer months by
turning off the water supply and power supply to the
dishwasher.
Moving or winterizing your dishwasher
Protect your dishwasher and home against water damage
due to freezing water lines. If your dishwasher is left in a
seasonal dwelling or could be exposed to near freezing
temperatures, have a qualified person do the following:
1. Disconnect power supply to the dishwasher.
2. Turn off water supply to the dishwasher.
3. Remove the 4 screws on the lower access panel.
Remove the lower access panel.
4. Place a shallow pan under the water supply valve.
Then, use a wrench to disconnect the water inlet from
the water supply valve. Separate the water inlet from
the water supply valve and drain water into the pan.
1. Water outlet
2. Spring clamp
3. Spring clamp
4. Water pump and motor
5. Water supply valve
6. Water inlet
7. Drain hose
5. Remove the spring clamp from the water outlet and
separate from the water supply valve; drain water into
pan.
6. Reconnect both water inlet and water outlet to the
water supply valve.
7. Empty the pan and reposition it under the water pump.
8. Remove the clamp and disconnect the drain hose from
the water pump; drain water into pan.
9. Reconnect drain hose to the water pump, being sure
to position the clamp over the connection.
10. Replace the lower access panel.
NOTE: If your dishwasher is connected to a garbage
disposal, do not run water into the sink after winterizing.
This could cause water to refill the drain hose on your
dishwasher.
Reconnecting your dishwasher
1. Remove the 4 screws on the lower access panel and
remove lower access panel.
2. Turn on the water supply to dishwasher.
3. Turn on power supply to dishwasher.
4. Run dishwasher through a complete cycle and check
for leaks.
5. Replace lower access panel.
1.
2.
3. 4.
5.
6.
7.