Filter
Top Products
2.
Select a wash cycle. See chart on page 9
for cycle descriptions.
For models with rocker switches:
Skip to Step 3.
For models with three buttons:
If the Pots 8 Pans cycle will be used,
push the POTS & PANS button.
For models with more than three
buttons:
Push a Cycle Selector button for the
desired cycle. Rinse & Hold cycle will
operate with any Cycle Selector button
selected. The Cycle Control knob deter-
mines which cycle operates.
3. Turn the Cycle Control knob clockwise to
point to the desired cycle. See page 9 for
cycle descriptions.
You will feel a definite stop at each cycle
mark. The dishwasher will automatically
start the cycls you selected.
NOTE:
If the door is latched, you will hear
cycles start
and
stop as the knob passes
each cycle mark. This is normal and will
not hurt the dishwasher. If you prefer, you
can set cycles with the door unlatched.
Cycles
may
vary with models
Cycles vary with
models
Adding a dish during a cycle
(model series TUD3000, TUDSOOO, TUD7000)
You can add an additional item to the dishwasher anytime before the Cycle Control knob
reaches LIGHT WASH. See page 9.
1. Lift up on the door latch to unlatch the
door and stop the cycle. Wait
a
moment
for the spray action to stop before open-
ing the door.
2. Open the door and add the dish.
3. Close
the door.
Do not latch it. Waif 30
seconds for air in the dishwasher to warm
up. This helps reduce the amount of
moisture that can come from the vent
when restarting the cycle.
4. Press door in to latch it. The dishwasher
will start where it stopped.
7