Filter
Top Products
11
Dishwasher Efficiency Tips
Hot water dissolves and activates the dishwashing detergent.
Hot water also dissolves grease on dishes and helps glasses dry
spot-free. For best dishwashing results, water should be 120°F
(49°C) as it enters the dishwasher. Loads may not wash as well if
the water temperature is too low. Water that is too hot can make
some soils harder to remove and cause certain detergent
ingredients not to function. If your water heater is located far from
the dishwasher, it may be necessary to run the hot water at the
faucet closest to the dishwasher to minimize the amount of cold
water in the water line.
To check water temperature
1. Run hot water at the faucet closest to your dishwasher for at
least 1 minute.
2. Place a candy or meat thermometer in a glass measuring
cup.
3. Check the temperature on the thermometer as the water is
running into the cup.
Additional efficiency tips
■ To save water and energy and time, do not rinse dishes
before putting them into the dishwasher.
■ Use a low energy, quick, or short cycle whenever possible.
These cycles use less hot water and energy than a normal
cycle.
■ Use a delay feature (on some models) to run your dishwasher
during off-peak hours. Local utilities recommend avoiding
heavy usage of energy at certain times of day.
■ During the summer, run your dishwasher at night. This
reduces daytime heat buildup in the kitchen.
■ Use the energy-saving dry option whenever possible. Allow
longer drying times (overnight) when using these options. Use
a rinse aid to improve drying.
■ Use cycles or options that add extra heat to the wash or rinse
portion of the cycle only when needed.
■ Run your dishwasher with full loads. Run a rinse cycle after
meals until the dishwasher is full.
■ If your home is equipped with a water softener, you may want
to avoid starting the dishwasher during the regeneration of
the softener, since this may contribute to poor wash
performance.
Cycle Selection Charts
Select the wash cycle and options desired and press START/
RESUME. The dishwasher starts filling once you press START/
RESUME, unless you select a delay wash. You can change
cycles and options as the machine is filling.
After completing a wash cycle, the dishwasher remembers the
cycle and options. It uses the same cycle and options again in
the next wash cycle, if you press only START/RESUME.
NOTE: If the door is opened during a cycle or the power is
interrupted, the Start/Resume indicator flashes. The cycle will not
resume until the door is closed and Start/Resume is pressed.
A “●” shows what steps are in each cycle. Your model may have
some or all of the cycles shown.
Display time is for models with the dual digit display on the
console.
These models meet the ENERGY STAR
®
guidelines for energy
efficiency.
Temperatures indicate where extra heat is added. The cycle
countdown (on some models) pauses at these points until water
reaches the temperature.
Water usage is shown in U.S. gallons/liters.
*If the incoming water is less than the recommended temperature
or food soils are heavy, the cycle will automatically compensate
by adding time, heat, and water as needed.
Pots & Pans
Use this cycle for hard-to-clean, heavily soiled pots, pans,
casseroles, and regular tableware. During the wash, the wash
action will repeatedly pause for several seconds.
Initial display time after rotating clock pattern: 92-99 min.
Use both detergent dispenser sections.
Pre-
Wash
Main
Wash
Rinse Rinse Final
Heated
Rinse
Dry Mini-
mum
Time
(min)
Water
Usage
(gal/L)
●●
140°F
(60°C)
●●
140°F
(60°C)
● 99*
Light
soil
6.9-7.8/
26.1-29.6
Normal
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.) During the wash, the
wash action will repeatedly pause for several seconds.
Initial display time after rotating clock pattern: 64-84 min.
Use both detergent dispenser sections.
Pre-
Wash
Main
Wash
Purge Rinse Final
Heated
Rinse
Dry Mini-
mum
Time
(min)
Water
Usage
(gal/L)
●●
120°F
(49°C)
●●
140°F
(60°C)
● 71*
Light
soil
5.6-6.8/
21.2-25.7
Rinse Only
Use this rinse cycle for rinsing dishes, glasses, and silverware
that will not be washed right away.
Initial display time after rotating clock pattern: 3 min.
Do not use detergent with this cycle.
Pre-
Wash
Main
Wash
Rinse Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
● 10 1.8-/6.8