Filter
Top Products
3
Electrical Requirements
Observe all governing codes and ordinances.
Required:
■ A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
■ A time-delay fuse or time-delay circuit breaker.
■ A separate circuit serving only this microwave oven.
Settings
Clock
The Clock is a 12-hour (12:00-11:59) clock, with A.M. and P.M.
Touch CLOCK, enter time, then touch CLOCK or the Start control.
Timer (on some models)
Timer can be used independently during any cooking program.
Touch the Timer control, enter time, then touch the Timer control or
the Start control.
Control Lock
Activate to avoid unintended start. Touch and hold the Cancel
control for about 3 seconds until 2 tones sound and padlock icon
appears in the display. Repeat to unlock control.
Options or Setup
Vent Timer, Light Timer, Filter Reset, Sound On/Off, Scroll Speed,
Demo Mode and Calibration may be changed.
Vent Fan
Various speeds, ranging from high to low, and off. Comes on
automatically as cooling fan during any cook function.
Vent Timer (on some models): Set vent fan to run for exactly
30 minutes, or to run for only 30 minutes more (off after
30 minutes). The vent fan may be turned off at any time using the
Vent Fan control. Touch the Options or Setup control to reach the
“Vent Fan” submenu, and select the setting.
Light Timer
Set the cooktop light to turn on and off at certain times. Touch
Options or Setup control to reach the “Light Timer” submenu, and
set the Light On Time and Light Off Time in hours and minutes with
A.M. or P.M.
Filter Reset
Reset the filter status after replacing and/or cleaning the filters.
Touch Options or Setup control to reach the “Filter Reset”
submenu and activate reset. See “Microwave Oven Care” section.
Tones
Programming tones and signals. Programming tones may be
turned off, or all tones (including end-of-function signals) may be
turned off. Touch the Options or Setup control to reach the “Sound
On/Off” submenu, and turn tones off or on.
Scroll Speed
Scroll speed of the text may be adjusted. Touch the Options or
Setup control to reach the “Scroll Speed” submenu, and select the
scroll speed. Touch the Start control to set speed.
Demo Mode
Activate to practice using the control without actually turning on
the magnetron or any heating element (on some models). Touch the
Options or Setup control to reach the “Demo Mode” submenu, and
activate or deactivate Demo Mode.
Calibration
The actual convection cooking temperature may be calibrated
higher or lower than the displayed temperature. Touch Options or
Setup control to reach the “Calibration” submenu. Use number
pads to select temperature variations in degrees Fahrenheit:
1= +5°, 2= +10°, 3= +15°, 4= +20°, 5= -5°, 6= -10°, 7= -15°,
8= -20° and 9= ±0° (reset to default).
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
GROUNDING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
■
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
This device complies with Part 18 of the FCC Rules.