Filter
Top Products
13
4. Remove the cap from the gas pressure regulator using a
flat-blade screwdriver.
NOTE: Make sure sealing washer remains in the same
position.
5. To convert to LP gas, unscrew the plastic adjustment screw
by hand, turn it over, and screw it in again.
6. Reinstall the cap.
To Convert Surface Burners
1. Remove burner grate, burner caps and burners.
2. Locate LP gas orifice spuds for top burners in the literature
bag included with the range. Three LP gas spuds are
stamped “88” and one “96.”
3. Remove Natural gas orifice spuds using a 7 mm combination
wrench.
4. Install LP gas orifice spuds using a 7 mm combination
wrench.
NOTE: Depending on model, the range cooktop may be
equipped with 4 standard burners or 3 standard burners and
1 super burner. Spud size and location remain the same.
For models with 4 standard burners:
For models with 3 standard burners and 1 super burner:
5. Place the Natural gas orifice spuds in the parts bag for future
use and keep with the bag containing literature.
6. Reinstall burners, burner caps and burner grates.
A. Cap
Inlet pressure
to Natural gas
Inlet pressure
to LP gas
A. Cap
B. Sealing washer
C. Adjustment screw
A. Burner cap
B. Burner
A
A
C
B
180
º
A
B
A. Spud
B. Holder
A
B
Std burner 88
Std burner 88
Std burner 88
Std burner 88
Std burner 88
Std burner 88
Std burner 88
Super burner 96