Filter
Top Products
4
NOTE: It is recommended that you do not install the refrigerator
near an oven, radiator, or other heat source. Do not install in a
location that receives direct sunlight or heat. Do not install the
refrigerator in a location where the temperature will fall below
55°F (13°C).
Electrical Requirements
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an extension
cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, shut cooling OFF by turning the control to
the “0” position, as shown. Disconnect the refrigerator from the
electrical source. When you are finished, reconnect the
refrigerator to the electrical source and reset the temperature
control to the desired setting. See “Using the Control.”
Reverse the Refrigerator Door
(optional)
IMPORTANT: All graphics referenced in the following instructions
are included later in this section after “Final Steps.” The graphics
shown are for a right-hand swing door (hinges factory installed on
the right).
Tools needed: No. 2 Phillips screwdriver
Remove Door and Hinge
1. Turn the refrigerator control OFF, and remove food and door
bins from doors.
2. Unplug refrigerator or disconnect power.
3. Place the refrigerator on its back.
4. Remove the bottom right leveling leg. See Graphic 3.
5. Using the Phillips screwdriver, remove the the screws from the
lower hinge assembly. See Graphic 3.
6. Pull the door downward to remove it from the cabinet.
Reverse Door Swing (optional)
1. Remove the upper hinge pin from the right side of the cabinet.
See Graphic 2.
2. Remove the plastic cap from the top left-hand side of the door
and reinstall it on the top right-hand side of the door, in the
previous pin location. See Graphic 1.
3. Reinstall the hinge pin on the left-hand side of the cabinet.
Align the hole in the door with the hinge pin and push up until
the hinge pin is inserted into the top of the door.
4. Remove the two retaining screws on the bottom left side of
the cabinet and reinstall them and the fixed foot on the right
side in the former lower hinge assembly screw positions. See
Graphic 4.
5. With the door closed, reinstall the lower hinge assembly on
the left side of the refrigerator. See Graphic 3.
6. Reinstall leveling leg. See Graphic 3.
5"
(13 cm)
3"
(7.5 cm)
3"
(7.5 cm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.