Filter
Top Products
Install properly.. .
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5 cm) between the refrig-
erator condenser and the wall.
3. Allow % inch (1.25 cm] on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
Level refrigerator-freezer...
This refrigerator has 2 threaded levelling legs that
are shipped in a separate package.
1. Screw these legs all the way into bolt holes in the
bottom front corners of the refrigerator.
2. Slide the refrigerator into place.
3. Adjust front legs to level the refrigerator.
- To raise corners, turn legs in direction shown.
-To lower corners, turn legs in direction shown.
4. Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
1. Rub briskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoilne, car-
bon tetrachioride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the tront.
Clean it.. .
Clean your refrigerator
before using it. See
Cleaf
ing instructions on pages
7 and 8.
Plug it in...
Refrigerator
Power Cord
RECOMMENDED GROUNDtNG METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4