Filter
Top Products
For Best Results
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent
against sorled surfaces of dishes, When a cycle IS started, the drshwasher fills with Water
to about the level of the heating element. This water IS pumped through the rotating
spray arms, drained through the filtersystem which removes food and soil, and pumped
back through the rotating spray arms. Soiled water is pumped out and replaced wrth
clean water during a cycle- the number of times depends on the cycle being used
The self-cleaning filtering system and
removable pump guard help eliminate pre-
rinsing by removing food particles from the
water.
Load dishes so soiled surfaces face pow-
erful spray from rotating arms.
The filtering system
It is not necessary to rinse dishes before
putting them into the dishwasher. Just remove
large pieces and quantities of food and bones.
The filtering system helps keep food particles
out of the wash water. Small partrcles are flushed
away as water is pumped out. Larger particles
are trapped in the pump guard.
To remove the pump guard for cleaning...
1. Wait at least 20 minutes atter a cycle for
the heating element to cool down.
2. Unload and remove the bottom rack.
3. Press the outside wall of the pump guard at
the center to release the latch.
4. Lift out and rinse clean.
voble Pump Guard
To replace the pump guard...
1 Insert pump guard legs [on inside wall] into
matching openings in filter screen.
2. Press down on outside wall until latch snaps
into place.
3. Replace bottom rack with rack bumpers in
front.
Water must be hot
For best cleaning and drying resutts, water should be at least
140°F (60°C).
1. Turn on hot water faucet nearest the dishwasher. Let water run
until it is as hot as possible.
2. Hold a candy or meat thermometer in the stream of hot water
to measure the temperature.
3. If the temperature is too low, have a qualified person raise
the water heater thermostat setting.