Whirlpool DU8300XT Dishwasher User Manual


 
Before starting your dishwasher
1. Read “Important Safety Instructions” on page
2 before starting your dishwasher.
2. Spin the Upper and Lower Spray Arms to
make sure nothing will stop them from turning
freely.
3. Push door firmly when closing and it will auto-
matically latch.
4. Run hot water at sink nearest dishwasher until
it is hot. Turn it off
CYCLE SELECTOR BUTTON
1.
OPTION SELECTOR BUTTONS
Starting your dishwasher
POTS & PANS cycle...
1. Turn Cycle Control Knob clockwise to dot
marked POTS 81 PANS. [POTS & PANS and NOR-
MAL WASH Cycles share the same spot on the
dial. The Selector Buttons determine which
cycle operates.] The dishwasher will auto-
matically start.
2. Push the POTS & PANS Selector Button only.
(The HEAT DRY option is preset. The AIR DRY
option can not be selected.)
LIGHT WASH cycle...
NORMAL WASH cycle...
1. Turn Cycle Control Knob clockwise to dot
marked NORMAL. (NORMAL WASH and POTS
& PANS Cycles share the same spot on the
dial. The Selector Buttons determine which
cycle operates.) The dishwasher will auto-
matically start.
2. Push the HEAT DRY or AIR DRY Selector Button.
RINSE & HOLD cycle...
1. Turn Cycle Control Knob clockwise to dot
marked LIGHT WASH. The dishwasher will au-
tomatically start.
2. Push the HEAT DRY or AIR DRY Selector Button.
Selecting a cycle
1. Turn Cycle Control Knob clockwise to dot
marked RINSE & HOLD. The dishwasher will
automatically start.
2. Push the AIR DRY Selector Button only.
POTS & PANS Cycle
Maximum cleaning for cooked- or
baked-on foods. Timer delays while
the dishwasher automatically heats
the water to 145 F (63 C] in both
washes and the last rinse [marked ‘1.
Cycle time will be about I!/2 to 2
hours, depending on time needed
to heat water
NORMAL WASH Cycle
A double wash for normal to heav-
ily soiled loads. [The Energy Guide
Label data is based on this Cycle.]
Cycle time is about 63 minutes.
lal - -
lil’l’l IA
LIGHT WASH Cycle
For normal, everyday soiled loads
Cycle time is about 58 minutes.
8