Filter
Top Products
6
Door Closing
Door Closing
Your wine cellar has four leveling legs. If your wine
cellar seems unsteady or you want the door to close more easily,
adjust the wine cellar’s tilt using the instructions below.
1. Plug into a grounded 3 prong outlet.
2. Move the wine cellar into its final location.
3. Turn the leveling legs to the right to lower the wine cellar
or turn the leveling legs to the left to raise it. It may take
several turns of the leveling legs to adjust the tilt of the
wine cellar.
NOTE: Having someone push ag
ainst the top of the wine
cellar takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
4. Open the door and check to make sure that it closes as easily
as you like. If not, tilt the wine cellar slightly more to the
rear by turning both front leveling screws to the right. It may
take several more turns, and you should turn both leveling
legs the same amount.
WINE CELLAR USE
Normal Sounds
Your new wine cellar may make sounds that your old one
didn’t make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your wine cellar is designed to run more efficiently to
keep your stored items at the desired temperatures and to
minimize energy usage. The high efficiency compressor and
fans may cause your wine cellar to run longer than your
old one. You may also hear a pulsating or high-pitched sound
from the compressor or fans adjusting to optimize
performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the wine cellar.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your wine cellar.
You may hear water running into the drain pan when the
wine cellar is defrosting.
You may hear clicking sounds when the wine cellar
starts or stops running.
Using the Control
The wine cellar has a push button control panel that allows
total cabinet temperature control. It also offers the option of
displaying and setting the temperature in Fahrenheit or Celcius.
Adjusting Controls
To adjust the temperature on the wine cellar, press the up or
down arrow once to enter the SET mode. The temperature
display will flash to let you know that the temperature can be
adjusted.
To make the wine cellar cooler, press the down button until
the desired temperture is reached.
To make the wine cellar less cool, press the up button until
the desired temperature is reached.
Each depression of the up or down arrow will adjust the
temperature 1 degree. The
temperature can be set between 39°F
and 64°F (4°C and 18°C).
NOTE: After the wine cellar has been turned off, wait 3 to
5 minutes before restarting.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install
wine cellar.
Failure to do so can result in back or other injury.
TEMP. SET
LIGHT
LAMPE
RUN
º
F
º
F
DISPLAY
RÉGLAGE DE TEMP.
Activation
AFFICHAGE
88 88