Filter
Top Products
Page 8
BUILT-IN CABINET INSTRUCTIONS
These appliances are designed for both built-in and free standing installation.
For built-in installation, ensure proper service access and ventilation, allow at least ¼” (6.35mm) space on
each side and at the top.
Cabinet Opening Dimensions (min.)
BWR-281DZ
BWR-461DZ
Width
15.5”
24.5”
Depth
23.5” + 2” handle
24.5” + 2” handle
Height
34.5”
34.5”
ELECTRICAL CONNECTION
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three-prong.
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly
grounded. The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevent
overloading house wiring circuits that could cause a fire hazard from overheated. Never unplug the
appliance by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage along its length or at either end. When moving the
appliance, be careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards, it is strongly recommended that you do not use an extension cord
with this appliance. However, if you must use an extension cord it is absolutely necessary that it be a
UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet
and that the electrical rating of the cord be 115 volts and at least 10 amperes.
INSTALLING STAINLESS STEEL HANDLES
This appliance includes stainless steel handles that are not required to operate this appliance. To install the
handles please follow the below instructions:
1. The gaskets(#1) are easily displaced by hand,
no tools are necessary.
2. Use a flat-head screwdriver to remove the two
pre-installed decorative plugs from the back of
doors. Note: Some wine refrigerators have no
decorative plugs.
3. Install the handle(#4) tightly as shown with two
screws(#3) and flat washers(#2) provided. (DO
NOT over tighten as this will cause damage to the
handles and stainless steel door frame(#5).
4. Replace the door gaskets to its original position.