Filter
Top Products
To Go Into Programming
Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button 4 (green) and then press and release ON/OFF button (yellow).
Continue holding BREW button. Display will read , wait until is displayed Enter the 4-digit access code, the digits 1-4 corre-
spond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then will be displayed.
PROGRAM MENUS
<TCT G3>
WILBUR CURTIS
WILBUR CURTIS WILBUR CURTIS
FILLING
WILBUR CURTIS
HEATING
WILBUR CURTIS
READY TO BREW
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
SELECTION or ENTER to save new parameter
Scroll RIGHT
431 2
Brew Volume (Factory set to 3.0 Gallons)
Selecting Brew by Volume or Brew by Time depends on whether you know your brew time before starting.
From Program Menus press > display will now show the next feature.
Recipe Select (Factory set to Standard Tea)
Press to Select. Press < or > to toggle between STANDARD TEA and TROPICAL TEA. Set and exit by press-
ing .
Brew by Volume: Press to Select, Display will now show Push START To Begin... Press the BREW button then
hot water starts running, when desired volume is reached press BREW button again to stop the flow. Now the
volume has been set. Pressing > button will display the subsequent menu features.
Brew by Time. Press to Select to change the brew time. Display will now show the current time. By pressing <
or > you can toggle back and forth from minutes to seconds to exit (ex). Change the time or set and exit by press-
ing . Brew by Time is programmable from 0:00 to 9:59. Increments are minutes and seconds.
Dilution Delay: Press to Select, Delay Time in minutes (m.) and seconds (s.) will display. Press < or > to
increase or decrease time. Range is from 30 seconds to 10 minutes.
Dilution Volume: Press to Select, Display will now show Push START To Begin... Press the BREW button then
hot water starts running, when desired volume is reached press BREW button again to stop the flow. Now the
volume has been set. Pressing > button will display the subsequent menu features.
Dilution Time: Press to Select, Display will now show current setting Time 0:00 and ex (exit) will flash. Press <
or > to toggle between minutes, seconds or exit. Pressing select to choose minutes will increase the minutes.
Press to add minutes. Press < or > to move to seconds or exit. Dilution Time is from 0:00 to 9:59. Increments
are minutes and seconds.
Dilution Stir (Factory set to ON).
Press to Select, press < or > to toggle between ON or OFF. Dilution Stir applies only to the Dilution cycle, by
pulsing the dilution time 45 seconds on, 5 seconds off.
2
Program Menus
Dilution Volume
Continued on Page 3
Brew By Volume
Dilution Delay
Dilution Time
Dilution Stir
Recipe Select
Brew By Time