Filter
Top Products
Dimensions in parentheses are in
millimeters unless otherwise specified.
10
W O L F DR AW ER M IC ROWAV E
E LE CT RI CA L R E Q U I R E M E N T S
G R O U N D I N G
I N S T R U C T I O N S
This appliance must be grounded. The drawer
microwave is equipped with a cord having a
g
rounding wire with a grounding plug. It must
be plugged into a wall receptacle that is
properly installed and grounded in accordance
with the National Electrical Code and local
codes and ordinances. In the event of an elec-
trical short circuit, grounding reduces risk of
electric shock by providing an escape wire for
the electric current.
Mounting
Flange
4 screws provided
Drawer installation
3-Prong Plug
Grounding Pin
3-Prong Receptacle
Ground Receptacle Box
Grounding
Improper use of the grounding plug can
result in a risk of electric shock. Do not
use an extension cord. If the power
supply cord is too short, have a qualified
electrician or serviceman install an outlet
near the appliance.
I
M P O R TA N T
N O T E
You must follow
all National
Electrical Code
regulations. In
addition, be aware
of local codes and
ordinances when
installing your
service.
D RAW E R I N S TA L L AT I O N
1)
Place the drawer adjacent to the wall or
cabinet opening. Plug the power supply
cord into the electrical outlet.
2)
Carefully guide the drawer into the
prepared opening. Avoid pinching the cord
between the oven and the wall.
3)
Slide the drawer all the way until the
mounting flange is flush with the face of
the cabinet. See illustration below.
4)
Open the drawer. Using the 4 holes on the
drawer as a template, pre drill the cabinet
using a
1
/16" (1.6) bit. See illustration below.
5)
Secure the drawer with the 4 screws
supplied. See illustration below.