Wolf Appliance Company PL342212 Ventilation Hood User Manual


 
5
Dimensions in parentheses are in
millimeters unless otherwise specified.
Planning Information
Pro Ventilation Hood Liner
MODEL PL342212
INSTALLATION NOTES
Refer to the illustrations and specifications
for overall dimensions and installation specifics.
Wolf Pro ventilation hood liners are recom-
mended for use with any Wolf cooking appli-
ance, and should be as least as wide as the
cooking surface. It is recommended that the
hood overlap the cooking surface by 3" (76) on
either side.
Installation of all Pro hood liners should be
30" (762) to 36" (914) from the bottom of the
decorative hood to the countertop. Follow the
dimensions shown in the Installation
illustration on page 4.
Wolf Pro hood liners are shipped without a
blower assembly. Internal, in-line or remote
blower assemblies are available. Blower options
also vary with the volume of air that needs to
be moved and the length of the duct run. Refer
to the charts at the end of this section for Pro
ventilation recommendations and blower
options.
IMPORTANT NOTE: Install this ventilation hood
liner only with a Wolf blower.
Pro hood liners require a separate, grounded
110/120 V AC, 60 Hz power supply. The service
should have its own 15 amp circuit breaker.
Placement of the electrical supply is not critical,
as long as you provide enough 120 V AC, 60 Hz
power cable to make the electrical connection.
Locate electrical within the shaded area shown
in the Installation illustration on page 4.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
A decorative hood can be created out of
wood, plaster, tile or metal. The shape of the
decorative hood is not critical. The only place
where the liner and outside cover must meet is
at the bottom edge of the metal liner. The deco-
rative hood and liner must fit at the bottom
edge in both width and depth.
The height of the liner does not have to be
the same as the height of the decorative hood
and is generally shorter.
The top depth of the liner, which is 12" (305)
standard, must be less than the interior depth
of the decorative hood. Measure the interior
depth of the hood at the top height of the liner
to make sure the liner will fit inside the decora-
tive hood.
The hood liner comes standard with a 4"
(102) lower reveal. Be sure to include this
dimension in your decorative hood selection.
Always use the interior measurements of the
decorative hood and measure in multiple places.
Use the smallest dimensions to verify hood liner
specifications.
Refer to the installation instructions shipped
with each Wolf product for detailed specifica-
tions. This information can also be found on
our website, wolfappliance.com.