Filter
Top Products
USER’S MANUAL
■
When the V-REV or H-REV mode is enabled, the text on the screen does not fli
p.
☞
NOTE
■
If you increase the SHARPNESS level too high, the picture may become distorted or noise
may appear.
•
CAM TITLE: If you enter a title, the title will appear on the monitor.
1) If the SPECIAL menu screen is displayed, use the Function Setup switch so that the
arrow indicates 'CAM TITLE'.
CAMERA T TLE SETUP
AB CD E FGH
J K L M
N O P Q R S T U V W X Y Z
a b c d e f g h i j k
m
n o p q r s t u v w x y z
l
2) Set it to 'ON' by using the Function Setup switch.
3) Press the Function Setup switch.
4) Use the Function Setup switch to move to a
desired letter and select the letter by pressing
the Function Setup switch
.
Repeat this to enter
multiple letters
.
You can enter up to 15 letters.
0 1 2 3 4 5 6 7 8 9
CLR
POS
END
-
.
5) Enter a title, move the cursor to 'POS' and
press the Function Setup switch
.
The entered
title appears on the screen
.
Select the position
to display the title on the screen by using the
Function Setup switch and press the Function
Setup switch
.
When the position is determined,
select 'END' and press the Function Setup switch
to return to the SPECIAL menu.
SHOP
■
When the CAM TITLE menu is ‘OFF’, no title will be displayed on the monitor screen even if
you enter one.
☞
NOTE
■
Only English is available in this mode.
■
If you move the cursor to CLR and press the Function Setup switch, all the letters are
deleted
.
To edit a letter, change the cursor to the bottom left arrow and press the Function
Setup switch
.
Move the cursor over the letter to be edited, move the cursor to the letter to be
inserted and then press the Function Setup switch.
•
SYNC : In areas where the supply is at 60Hz(NTSC), 50Hz(PAL), you can synchronize the
output phase of multiple cameras using the power synchronization function (Line-Lock)
without
using a synchronization signal generator.
- INT: Internal Synchronization Type
-L/L: Power Synchronization Type, Line-lock(AC24V Power)
* Press the Function Setup switch.
* You can select a desired phase from 0 to 359 when select 'phase'.
17