Zanussi BST 6 Microwave Oven User Manual


 
8
Remove all packaging, both inside and
outside the oven, before using the oven.
Before first use, the oven should be heated without food.
During this time, an unpleasant odour may be emitted.
This is quite normal.
1. Switch the oven function control knob to conventional
cooking .
2. Set the thermostat control knob to MAX.
3. Open a window for ventilation.
4. Allow the oven to run empty for approximately 45
minutes.
5. Half way through, reset the oven function control to
fan cooking .
This procedure should be repeated with the grill
function for approximately 5-10 minutes.
Always cook with the oven door closed.
Stand clear when opening the drop down oven door.
Do not allow it to fall open - support the door using
the door handle, until it is fully open.
The oven has four shelf levels (Fig. 7 Page 3), and
is supplied with two shelves. The shelf positions are
casted from the bottom of the oven as shown in the
diagram.
It is important that these shelves are correctly
positioned as shown in the diagram.
Do not place cookware directly on the oven base.
Cookware
Use any oven proof cookware which will withstand
temperatures of 250°C.
Baking trays, oven dishes, etc. should not be placed
directly against the grid covering the fan at the back
of the oven, or placed on the oven base.
Do not use baking trays larger than 30 cm x 35 cm
(12 in x 14 in) as they will restrict the circulation of
heat and may affect performance.
The effects of dishes
on cooking results
Dishes and tins vary in their thickness, conductivity,
colour, etc. which affects the way they transmit heat to
the food inside them.
A Aluminium, earthenware, oven glassware and bright
shiny utensils reduce cooking and underneath
browning.
B Enamelled cast iron, anodized aluminium, aluminium
with non-stick interior and coloured exterior and
dark, heavy utensils increase cooking and underneath
browning.
Condensation and steam
When food is heated it produces steam in the same way
as a boiling kettle. The oven vents allow some of this
steam to escape. However, always stand back from
the oven when opening the oven door to allow any
build up of steam or heat to release.
If the steam comes into contact with a cool surface on
the outside of the oven, e.g. a trim, it will condense and
produce water droplets. This is quite normal and is not
a fault with the oven.
To prevent discoloration, regularly wipe away
condensation and also soilage from surfaces.
Before the First Use
Using the Oven
Push-Pull Control Knobs (Fig. 4 Page 3)
All the models, except model BMS 641 X, are provided
with push-pull control knobs.
These knobs can be completely sunken inside the
control panel when the oven is not working.