Filter
Top Products
11
30
20 min
60
a
b
FO 1013
3
Dimensions are given in mm.
Building over a kitchen unit with
door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be hot when in
operation. The recommended solution is shown in
diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical
assistance is needed. The space behind the kitchen
unit ("b") can be used for connections.
Fitting the hob to the worktop
Before fitting the hob into the cut out, an adhesive
sealing gasket supplied with the hob must be fitted to
the edge of the cut out. It is essential that no gaps are
left in this seal in order to prevent spillage near the
hob seeping into the cabinet below.
1) Place the sealing gasket all around the edge
of the cut out.
2) Place the hob into the cut out and secure it
by means of the relevant fixing clamps and
screws, as shown in the diagram.
3) When the screws have been tightened, the
excess seal can be removed.
The edge of the hob forms a double seal which
prevents the ingress of liquids.
☞
FO 0199
Seal