Filter
Top Products
4
Washing programmes
Programme Degree of soil
and
type of load
Starting
position of the
programme
selector dial
Heavy soil
Crockery, cutlery,
pots and pans
Normal soil
Crockery and
cutlery
Any.
Partial load (to
be completed
later in the day).
Cycle description
(1) INTENSIVE
65°C
NORMAL
65°C
RINSE & HOLD
Cold prewash
Main wash up to 65°C
1 cold rinse
1 hot rinse
Drying
Main wash up to 65°C
1 cold rinse
1 hot rinse
Drying
1 cold rinse (to avoid
food scraps from
sticking together).
(1) Testing programme for EN 50242 (see "Hints for Test Centres").
(2) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by
the variations of the power supply.
A
B
C
(2) Consumption values
Programme duration
(in minutes)
Energy
consumption
(in kWh)
Water
consumption
(in litres)
76
1,1
17
70 1,1 14
10
0,1
11
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Set and start of the programme
Turn the programme selector dial clockwise until the
letter of the programme you wish to select corresponds
with the programme marker on the control panel.
Depress the On/Off push button.
The On/Off indicator light will come on and the machine
will start.
5. Interrupting a washing programme
in progress
Interrupt a washing programme in progress ONLY if
it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
b) Press the On/Off push button (in this case the On/Off
indicator light turns off). Press the On/Off push button
again; the programme will start from the point in
which it was interrupted.
6. End of the washing programme
The dishwasher will automatically stop.
The On/Off indicator light remains on until the On/Off
push button is depressed.
Only the On/Off integrated indicator light will remain on.
Switch off the dishwasher by pressing the On/Off push
button.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.
Water may appear on the sides and door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Operating sequence