Filter
Top Products
16
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the ON-OFF push
button
The ON-OFF indicator light will come on and
in the digital display appear three horizontal
lines (---).
3. Check that there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms
can rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the recommended
quantity given in the Washing programmes
chart.
Important!
If the half load option is selected
remember to reduce the quantity of
detergent.
Close the detergent dispenser lid.
The setting of the programme is
possible:
With the door open, in this case the selected
programme and eventual options will start
automatically 5 seconds after the closing of the
door.
With the door closed, in this case the
selected programme and eventual options will
start automatically 5 seconds after the last
pressure of a push button.
7a. Setting and starting the
programme without delay start
Press the push button corresponding to the
required programme: in the digital display will
appear the time duration in minutes of the
programme and the phase indicator lights for
that programme will illuminate.
Select, if required, the HALF LOAD option.
The corresponding indicator light will illuminate
and the duration of the programme in the digital
display will be confirmed.
If the setting has been made with the door
open, close the door and the programme will
start automatically after 5 seconds.
Until the door remains opened it is possible to
change the setting.
If the setting has been made with the door
closed, the programme will start automatically
5 seconds after the last pressure of a push
button.
The start of the programme will be confirmed
by an audible signal, the phase indicator lights
will turn off except for the phase under way.
The duration of the programme visible in the
digital display will start to decrease from minute
to minute.
7b. Setting and starting the
programme with delay start
Once a programme and required options
have been selected (see point 7a) to set the
delay start proceed as follows:
Press the DELAY push button, in the digital
display will appear h 1.
Operating sequence