Zanussi DWS 909 Dishwasher User Manual


 
Dimensions Width 60cm
Height with worktop 85 cm
Height without worktop 82 cm
Max depth 61 cm
Max depth with open door 115.2 cm
Electrical connection Voltage 220/240 V - 50 Hz
Motor rating during wash 200 W
Power of heating element 2100 W
Overall power 2300 W
Water supply pressure Minimum 50 kPa (0.5 bar)
Maximum 800 kPa (8 bar)
Capacity 12 place settings
Technical specifications
6
Adjusting the worktop
You can move the worktop forward or backward by
25 mm in order to align the machine with other kitchen units.
Simply unscrew the two rear retaining screws, move the top to
the required position and then retighten the screws.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s
worktop, you can install it
under a close fitting sink unit
or a pre-existing top,
providing the dimensions of
the recess correspond to
those shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by unscrewing the two rear
retaining screws, pull from the front and slide out the rear
slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
IN26
820
570 - 600
600
IN05