Zanussi ZBF 260 Oven User Manual


 
14
Something not working
SYMPTOM
The oven does not come on
The oven temperature light does not come on
The oven light does not come on
It takes too long to finish the dishes, or they are
cooked too fast.
Steam and condensation settle on the food and the
oven cavity.
The electronic programmer does not work
The oven fan is noisy
SOLUTION
Check the oven is in manual operation and that both
a cooking function and temperature have been selected.
Check the oven is wired in properly, and the socket
switch or the switch from the mains supply to the oven
are ON.
Select a temperature with the thermostat control knob
Select a function with the oven function control knob.
Select a function with the oven function control knob
Check the light bulb, and replace it if necessary (see
"Replacing the Oven Light")
The temperature may need adjusting
Refer to the contents of this booklet, especially to the
chapter “Using the Oven”.
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
Check the instructions for the timer.
Check that shelves and bakeware are not vibrating in
contact with the oven back panel.
If the appliance is not working correctly, please carry out the following checks, before contacting your local Service
Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
a charge will be made even if the appliance is under guarantee.
If after all these checks, the oven still does not work,
contact your local Service Force Centre quoting your
model and serial number, which can be found on the rating
plate. Please note that it will be necessary to provide proof
of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the above
checks have been made as the engineer will make
a charge if the fault is not a mechanical or electrical
breakdown.