Zanussi ZBT3204 Refrigerator User Manual


 
It is important to periodically clean the defrost water drain
hole in the middle of the refrigerator compartment channel
to prevent the water overflowing and dripping onto the
food inside. Use the special cleaner provided, which you
will find already inserted into the drain hole.
Defrosting the freezer
A certain amount of frost will always form on the
freezer shelves and around the top compartment.
Important! Defrost the freezer when the frost layer reaches
a thickness of about 3-5 mm.
To remove the frost, do these steps:
1. Switch off the appliance.
2. Remove any stored food, wrap it in several layers of
newspaper and put it in a cool place.
3. Leave the door open.
4. When defrosting is completed, dry the interior thor-
oughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain the maximum
coldness and run the appliance for two or three hours
using this setting.
7. Reload the previously removed food into the com-
partment.
Important! Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it. Do not use
a mechanical device or any artificial means to speed up
the thawing process other than those recommended by
the manufacturer. A temperature rise of the frozen food
packs, during defrosting, may shorten their safe storage
life.
Periods of non-operation
When the appliance is not in use for long periods, take
the following precautions:
disconnect the appliance from electricity supply
remove all food
defrost
4)
and clean the appliance and all accessories
leave the door/doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it
once in a while to prevent the food inside from spoiling
in case of a power failure.
What to do if…
Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Problem Possible cause Solution
The appliance does not operate.
The lamp does not operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected to the
mains socket correctly.
Connect the mains plug to the mains
socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
4) If foreseen.
7