Filter
Top Products
Door reversal directions
1. Disconnect from the electricity supply.
2. Gently lay the fridge on its back with the top held
away from the floor by 5-8 cm (2-3 inches) of
packing;
3. Remove the bottom hinge (3), pin (1) and screw
(2);
4. Slide out the fridge door from pin (D), unscrew the
latter and then refit it on the opposite side;
5. Unscrew the foot on the left side and refit it on the
opposite side;
6. Remove the two screws which mask the holes for
fixing the hinge from the left hand side;
7. Refit the door and the lower hinge (turning it
180¡), the pin (1) and the screw (2) as shown in
the Figure;
8. Remove plugs, unscrew the handle and refit it on
the opposite side.
Important
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer on a low setting.
D336
180°
1
3
2
D299
2
D
D590
Printed on recycled paper