Zanussi ZCF 220 Freezer User Manual


 
5
TTEEMMPPEERRAATTUURREE CCOONNTTRROOLL
The thermostat ensures that the required temperature is
maintained in the freezer. Adjust the temperature by turning
the button with a coin that fits the groove. Turning the
thermostat button towards no. 7 makes the temperature in
the freezer colder, and turning the button towards no. 1
makes the temperature warmer. The correct setting can be
found by measuring the temperature of the top package in
the middle of the freezer. This should not have a
temperature higher than -18°C.
OOPPEENNIINNGG//CCLLOOSSIINNGG TTHHEE LLIIDD
The lid is fitted with a tightly closing sealing strip to prevent
moisture getting inside the freezer and increasing the
amount of frost formed.
When the lid is opened the air inside the freezer becomes
slightly warmer and expands.
As soon as the lid is closed again the air is cooled
immediately.
This may lead to the creation of a vacuum which makes it
hard to open the lid immediately after it has been closed.
This is quite normal.
Wait a few minutes until the vacuum has disappeared, then
open the lid by pulling gently. Never pull the handle
violently.
CCOONNTTRROOLL PPAANNEELL
The green light is illuminated as long as the freezer is
connected.
The yellow light is illuminated when the Super button is
depressed. See under Freezing.
The red light is illuminated when the temperature in the
freezer is higher than the thermostat setting (alarm).
The red alarm light can be due to:
Insertion of a large amount of fresh food. The red
alarm light will go out after a while.
Opening the lid too long. The red alarm light will go
out after a while.
A defect in the system. See under If something does
not work.
FFRREEEEZZIINNGG
It is important that fresh food placed in the freezer is
frozen quickly, and that the food already in the freezer is
heated as little as possible in this connection.
If more than 3-4 kg of food is to be frozen:
Press the square Super button (yellow light comes
on). The freezer will now run continuously, creating a
sufficient reserve of the temperature required.
Press the Super button 6-24 hours before placing
fresh food in the freezer, depending on how much
food is to be frozen.
Place the food in the freezer and leave the Super
button on for about 24 hours more.
Then press the Super button again (yellow light goes
off). The freezer will return to normal storage
temperature. If you forget to press the Super button
again, the freezer will not be damaged by running at
the Super setting for some time - but energy will be
wasted.
HOW TO USE