Filter
Top Products
PPOOSSIITTIIOONN
Place the freezer horizontally on a firm surface, resting
on all four plastic feet. Use a wooden block or similar
object to compensate for any bumps/holes in the
surface.
The room should be dry and adequately ventilated.
If the room temperature exceeds 43°C, or falls below
freezing point, the freezer will not function as it should.
Do not place the freezer close to sources of heat,
radiators, chimneys, etc., and do not place the freezer in
direct sunlight.
If the freezer has been handled standing on end it should
be allowed to stand in normal position for about 12 hours
before switching it on.
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
SSWWIITTCCHHIINNGG OONN
Before switching on, the freezer should be cleaned inside.
See under Maintenance.
Set the thermostat button in middle position. Allow the
freezer to run for several hours before placing food inside.
EELLEECCTTRRIICCAALL RREEQQUUIIRREEMMEENNTTSS
Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating
plate, located inside the lid.
4
INSTALLATION
Warning:
This appliance must be earthed.