Filter
Top Products
Lighting the appliance
The system works by means of an electric spark system. Details about
the plug are given in 'General Information'.
Hotplate
To light:
1. Lift up the lid. You cannot use the hotplate when the lid is down.
2. Push in and hold the control knob, turn to the large flame symbol
(highest setting) and press the ignition button immediately. Keep the
control knob depressed for up to 5 seconds, but no longer than 10
seconds. After this time release the controls. The flame should
remain alight. If after 10 seconds the burner has not lit, stop
operating the appliance and wait at least 1 min before attempting a
further ignition of the burner.
Warning: If the ignition button is not pressed immediately a build up of
gas may cause the flame to spread.
Please note: If you have any trouble lighting a hotplate burner turn all
the hotplate control knobs off. Make sure the hotplate burner parts have
been replaced correctly.
Z C G 7 6 9 1
4
Lighting the appliance
For your safety
In the event of the burner flames being accidentally extinguished,
turn off the burner control and do not attempt to re-ignite the burner
for at least 1 min.
For your safety
If you close the lid of the appliance while any of the hotplate
burners are lit the gas will go out. This is because it would be
dangerous if the burners stayed on when the lid was closed.
Always use the control knob to turn off a burner. Do not use
the lid as a cut-off device. This will only cut off the gas when
the lid is closed. The gas will flow again when the lid is
opened.
BACK LEFT