Filter
Top Products
35
PRESSURE TESTING
1. The Rapid injector is used as a pressure test point.
2. Connect the pressure gauge to the Rapid injector.
3. Check the supply pressure by turning the Rapid burner on and one other hotplate burner full on and light the
appropriate burner. The pressure should be either:-
(i) For Natural Gas 20mbar
(ii) For LP. Gas. The pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane.
4. Turn off the taps, disconnect the pressure gauge.
5. Check operation of each hotplate burner.
CHECKING THE GRILL
Place the grill pan containing the grid into the grill compartment. Open the grill door and turn the grill control to full
on. Visually check that the element is heating up.
CHECKING THE HOTPLATE
Fit the burner crowns and caps ensuring that they are correctly seated. Fit the pan supports. Check each of the
hotplate burners in turn by turning the hotplate tap to its full on position and pushing the ignition button. As soon
as the burners are lit the button can be released.
CHECKING THE TIMER TO SET THE TIME OF DAY (SEE FIG.5).
1. Turn on the electricity supply and ensure that the thermostat
is in the off position.
1a. Before setting timer read important note below.
2. Rotate the left hand clock knob to 'Manual' and back to the
'Time Setting' position.
3. Set the time of day by rotating the right hand knob. Note
that it is a 24 hour clock.
4. Rotate the left hand clock knob back to the 'Manual' position.
NOTE: When setting the time of day with the knob in the 'Time Setting' position only, this will activate the timer for
seven seconds after selection. This means that when setting the time of day in this function the time can only be
set by using the right hand knob within a seven second period.
After seven seconds have elapsed from when the correct time of day has been set, the timer ceases to be active
and subsequent operation of the right hand knob will not change the time setting.
AUTOMATIC OPERATION
Having set the clock up as described above, turn the left hand knob to the 'Cook Time' position and set the right
hand knob to show a cooking time of two minutes (0.02).
Turn the left hand knob to the 'End Time' position; the time shown on the display is now the time of day with two
minutes added on. Rotate the right hand knob to add two minutes to this time to give a two minute delay.
Turn the left hand knob to the 'Automatic' position to complete the programming sequence, the clock now shows
the time of day again with 'Auto' glowing continuously.
Turn the oven thermostat on and two minutes after setting, the oven light should illuminate and the fan should
start to run.
Two minutes after the lighting sequence has started the timer should cut off the electricity supply to the oven and
the audible signal should sound. The signal is continuous it may be switched off at any time by rotating the left
hand knob.
Return timer to manual by rotating the left hand knob to the 'Manual' position.
INSTALLATION INSTRUCTIONS
Fig. 5.