Filter
Top Products
5
Zanussi 818 14 54-03/7
Before use
·Check that the drain hose at the rear of the cabinet
discharges into the drip t ray.
·Remove all securing tapes.
·Wash the inside of the appliance with lukewarm
water with a little bicarbonate of soda added (5ml to
0,5 litre of water). Do not use soap or detergent as
the smell may linger. Dry the appliance thoroughly.
Do not use detergents, abrasive powders,
highly perfumed cleaning products, wax,
polishes or products containing alcohol.
·Before inserting the power plug into the outlet and
switching on the cabinet for the first time, leave it
standing upright for about 30 minutes, or for 2 hours
if it was t ransported horizontally. Otherwise the com-
pressor may sustain damage. This time will allow t he
oil sufficient time to return to the compressor.
To start the fridge and thermostat
control
Turn the thermostat control to the desired position.
1 :
The lowest position of the thermostat control results
in the highest temperature inside the cabinet.
6 :
The highest position of the thermostat control results
in the lowest temperature inside the cabinet.
0 :
Of f.
Allow the cabinet to run for a period of 24 hours
whenever the temperature setting is changed. This
will allow the temperature to stabilise inside the
cabinet.
A suitable temperature inside the fridge is approx.
5°C. If the thermostat control is set too cold, food
with a high water content may start to freeze if it has
been placed in the coldest places in the fridge. The
picture shows the coldest and warmest places inside
the fridge.
(+ warm, - cold)
Meat, fish and milk should be put in the coldest part
of the cabinet.
The temperature will be affected by:
· How often the door is opened
· How much food is stored
· Position of the appliance (See chapter
Installation)
+
+
+
+
--
--
--
--
+
+
+
+