Filter
Top Products
20
CLEANING THE HINGED GRILL
This model has been fitted with a hinged grill element
to enable you to clean the roof of the oven easily.
Before proceeding ensure the oven is isolated from
the electricity supply. Then undo the screw which
holds the grill in place. (see Fig. 12)
Fig. 12
Then gently pull the grill downward to allow access to
the oven roof. (see Fig. 13)
Fig. 13
Clean the oven roof with a suitable clener and wipe
dry before replacing the hinged grill element.
Gently push up the grill element into place and firmly
screw into place the holding nut.
NOTE: Ensure the grill holding nut is firmly in
place to avoid the grill falling down during
operation.
WHAT HAPPENS IF SOMETHING GOES WRONG
If the oven does not come on:
* Check the oven is in manual operation
* Check that the switch from the mains supply to the
oven is ON
* Check that the fuse in the fuse box is intact
In after all these checks, the oven still does not work,
contact your local Zanussi Service Centre quoting
your model and serial number.
Please note that it will be necessary to provide proof
of purchase for any inguarantee service calls.
In-guarantee customers should ensure that the
above checks have been made as the engineer
will make a charge if the fault is not a mechanical
or electrical breakdown.
CUSTOMER CARE DEPARTMENT
For general enquiries concerning your Zanussi
appliance, contact our Customer Relations
Department by letter or telephone as follows:
Customer Care Department
Zanussi House
Hambridge Rd.
Newbury
Berks R14 5EP
Tel: 01635 - 521313
FO 1168
FO 1169