Zanussi zdf231 Dishwasher User Manual


 
Drain hose
Connect drain hose to
the sink. Secure it with
the supplied hose clamp.
Required height: 30 to
100 cm above bottom of
the dishwasher.
Ensure that the hoses
are not kinked, crushed
or entangled.
When connecting the
drain hose to an under
sink trap spigot, the en-
tire plastic membrane
(A) must be removed.
Failure to remove all the
membrane will result in
food particles building up
over time eventually
blocking the dishwasher
drain hose spigot.
If you use a drain hose extension the total
length should not be longer than 4 metres.
Likewise the internal diameter of the couplings
used for connections to the waste outlet must
be no smaller than the diameter of the hose
provided.
Electrical connection
CAUTION!
Safety standards require the appliance to be
earthed.
Prior to using the appliance for the first time,
ensure that the rated voltage and type of supply
on the rating plate match that of the supply
where the appliance is to be installed.
The fuse rating is also to be found on the rating
plate.
Always plug the mains plug into a correctly in-
stalled shockproof socket. Multi-way plugs,
connectors and extension cables must not be
used.
This could constitute a fire hazard through over-
heating.
If necessary, have the domestic wiring system
socket replaced. In case that the electrical ca-
ble has to be replaced, contact your local Serv-
ice Force centre.
The plug must be accessible after the appliance
has been installed.
Never unplug the appliance by pulling on the
cable. Always pull the plug.
The manufacturer accepts no liability for failure
to observe the above safety precautions.
24