Filter
Top Products
9
HOW TO FINISH UNPACKING
· Place appliance next to the cabinet in which it
will be installed.
· Remove the appliance packing except for
bottom tray which should be left in position
until the appliance is ready to be fitted into its
cabinet.
· Ensure the owner is given these operating
instructions.
TOOLS REQUIRED
The following tools will be needed and it helps to
assemble them before starting to install your oven:
A terminal screwdriver (3mm wide blade)
A pozidrive screwdriver
Pliers
Wirestrippers
Knife
Sidecutters
Adhesive tape
Tape Measure
MAKING THE ELECTRICAL
CONNECTIONS
PREPARING CABLE
We recommend you use a new length of cable to
ensure your safety.
· Ensure you have the correct length of cable
appropriate to the wiring method you are using.
When fitting new cable allow sufficient cable
for removal of the unit at a later date, should it
be necessary.
· Score, but do not cut through, around the
sheathing with a knife 100mm (4in) from each
end of the cable and break through to the
encased wires by bending the cable
backwards and forwards to fatigue the
sheathing.
· Carefully score down from each of the cable
sheathing along the length of the bare earth
wire (if a cut was made along the length of the
live or neutral wires, it might cut into their
sheathing) to the cuts already made.
· Carefully prise open the sheathing at each end
of the cable to expose the encased wiring.
TO REMOVE COVER OF MAINS
TERMINAL
From the rear of the appliance, remove mains input
terminal cover to gain access to terminal block.
· First remove retaining screw with pozidrive
screwdriver. See Fig. 3.
· Prise cover loose using screwdriver in position
(1) then lever off with screwdriver in position
(2) at either side. See Fig. 4.
Important: Switch off at mains, miniature
circuit breaker and if appropriate, remove
fuse before commencing any electrical work.
Fig. 3
Fig. 4