Zanussi ZDQ495 Oven User Manual


 
7
THINGS YOU NEED TO KNOW
WARNINGS
· This appliance must be installed by a qualified
electrician/competent person. Safety may be
impaired if installation is not carried out in
accordance with these instructions.
· This appliance must be earthed.
· Do not remove the screws from the earth tab
extending from the oven mains terminal block
(Fig. 6).
· Before connecting the appliance make sure
that the voltage of your electricity supply is the
same as that indicated on the rating plate. This
is situated on the lower front frame of the
appliance and can be seen upon opening the
top cavity door. Alternatively the rating plate
may also be found on the back or top of some
models (where applicable).
· Do not alter the electrical circuitry of this
appliance.
THINGS TO NOTE
· This appliance is designed to be fitted in
cabinets of the recommended dimensions as
shown (Fig. 2).
· If your cabinet interior dimension is between
565-570mm the oven may still be fitted.
However a minor modification to the cabinet
will be required to reduce the aperture size
down to 560-565mm. To allow the product to
be securely screwed into the cabinet.
· The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
· Enquiries regarding the installation of the
cooker point, if required, should be made to
your Regional Electricity Company to ensure
compliance with their regulations.
· The cooker socket switch should be outside
the cabinet but within 2m of the appliance to
make it accessible to switch off the appliance
in case of an emergency.
· To protect the hands, wear gloves when lifting
the oven into its housing.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried
out before the appliance is connected to the mains
supply and re-checked after fitting.
GETTING THINGS READY
CHOICE OF ELECTRICAL CONNECTION
· There are three possible ways to connect your
appliance. In each case the appliance should
be operated using at least 6mm
2
twin core and
earth PVC insulated multicore cable. Please
choose from the most appropriate after reading
the different methods:-
a) By connecting the appliance to a cooker point
(having a double pole isolating switch with at
least 3mm contact separation in all poles and
neutral) and protected with a fuse or miniature
circuit breaker at your mains fuse box.
b) By connecting the appliance together with a
hob directly to a cooker point(s). Having a
double pole isolating switch with at least 3mm
contact separation in all poles and neutral.
c) If you wish to connect an oven and a hob to a
cooker point you can by connecting the oven
and hob separately to the cooker point. Oven
and hob units should be separately connected
to a cooker point. See Fig. 1.
NOTE: It is good practice to :
· Fit an Earth Leakage Circuit Breaker to your
house wiring.
· Wire your appliance to the latest IEE
regulations.
PREPARING CABINET FOR FITTING OF OVEN
· Make sure that the cabinet is the correct size
for the appliance to be fitted (Ref. Fig. 2).
· If the cabinet is between 565-570mm, then the
cabinet should be modified so that at the screw
fixing points the recommended dimension of at
least 560-565mm is maintained. The
modification should ideally be localised to
ensure that after screw fitment the oven is
securely fixed into position.
· The cabinet must be stable and level securing
it to the wall or floor. If necessary, make
arrangements to ensure the shelf upon which
the oven will rest is level.
· When the appliance is installed ensure a
minimum gap of 2mm is maintained between
the trim on the bottom edge of the appliance,
and any corresponding door / panel.
Fig. 1
INSTALLATION INSTRUCTIONS
Subject to Regional Electricity Companies
regulations if you wish to connect the oven
and hob to the power supply you may use
one of the following two methods:-