Filter
Top Products
14
Aligning the appliance top with the
other kitchen units
The appliance comes with the top aligned with the
door. To change the alignment, follow the instructions
below:
Remove the screws (A-Fig.) fixing the rear brackets
to the top; move the top and, having selected the
new position, refit the screws.
Installation
Positioning
For this appliance to work efficiently, it must not be
located where the temperatures will fall below 10°C
(50°F) or rise above 38°C (100°F), e.g.
conservatories.
For correct operation this appliance must be located
in a dry atmosphere, away from heat sources, e.g.
cookers, radiators, boilers and direct sunlight.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There
should be 100mm (4”) between the top of the cabinet
and any overhanging kitchen furniture. Alternatively
allow 50mm (2”) between the top of the cabinet and
any overhanging kitchen furniture and a gap of
25mm (1”) on either side of the appliance.
Do not obstruct the space underneath. The back of
the cabinet may be placed close to the wall but must
not touch it. DO NOT install in places with restricted
ventilation.
50-100 mm10 mm
10 mm
A
B
NP006
Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers.
D200
It is important that the bottom grill is not obstructed
as the air must circulate freely through this grill.
D086_a