Filter
Top Products
5
Cast Iron Pan Supports
The hob has cast iron pan supports.
Take care when removing them. They are fair heavy and
could damage the hob or your kitchen furniture if you let
them fall down.
To keep the pan supports in the correct position, they
are hooked into hinges at the back of the hob. When
removing the pan supports, lift them up as shown in the
diagram. Never turn the pan supports on the hinges, this
could damage them.
Wash the pan supports using hot soapy water. If
necessary, a paste cleaner or a soap impregnated steel
wool pad can be used with caution.
The Burners
The burner caps and crowns can be removed for cleaning.
Wash the burner caps and crowns using hot soapy water,
and remove marks with a mild paste cleaner. A well
moistened soap impregnated steel wool pad can be used
with caution, if the marks are particularly difficult to
remove.
After cleaning, be sure to wipe dry with a soft cloth.
Fig. 1
Something Not Working?
If the hob is not working correctly, please carry out the following checks before contacting your local Zanussi Service
Force Centre.
SYMPTOM
n There is no spark when lighting the gas
n The gas ring burns unevenly
SOLUTION
u Check that the unit is plugged in and the electrical
supply is switched on
u Check that the RCCB has not tripped (if fitted)
u Check the mains fuse has not blown
u Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
u Check the main jet is not blocked and the burner
crown is clear of food particles.
u Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
If after all these checks, your hob still does not operate
correctly, contact your local Zanussi Service Force
Centre.
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the
above checks have been made as the engineer
will make a charge if the fault is not a
mechanical or electrical breakdown.
YES
NO