Zanussi ZGF 780 IT Cooktop User Manual


 
8
Lighting the burnersLighting the burners
Lighting the burnersLighting the burners
Lighting the burners
For easier lighting, proceed before
putting a pan on the pan support.
To light a burner:
z turn the relevant knob anti-clockwise to
maximum position (
), then push it
down to ignite the burner.
z Upon ignition, keep the knob pushed
down about
5 seconds. This will
allow the "thermocouple" (see Fig.1 -
letter D) to be heated and the safety
device to be switched off, otherwise
the gas supply would be interrupted.
z Then adjust the flame as required.
If the burner accidentally goes out, turn
the control knob to the "off" position
and wait for at least 1 minute before
trying to light the burner again.
If you cannot light the flame even after
several attempts, check the "cap"
(see Fig.1 - letter A) and the"crown"
(see Fig.1 - letter B) are in the correct
position.
To switch off a burner:
z To put the flame out, turn the knob to the
symbol ( z
).
)
OperationOperation
OperationOperation
Operation
Hob burners control knobsHob burners control knobs
Hob burners control knobsHob burners control knobs
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply (“off” position)
there is maximum gas supply
there is minimum gas supply
z
AA
AA
A - Burner cap
BB
BB
B - Burner crown
CC
CC
C - Ignition electrode
DD
DD
D - Thermocouple
Fig. 1
A
B
C
D
Triple crown burner
)