Filter
Top Products
13
INSTALLATION
If this refrigerator featuring magnetic door seals is to replace
an older appliance having a spring lock on the door or lid, be
sure to make that spring lock unusable before you discard the
old appliance.
This will prevent it from becoming a death-trap for a child.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Best performance is obtained with
ambient temperature between +18°C and +43°C
(class T); +18°C and +38°C (class ST); +16°C and
+32°C (class N); +10°C and +32°C (class SN).
The class of your appliance is shown on its rating plate.
Power connection
Before plugging the appliance into the mains
socket, check that the voltage and frequency
indicated on the appliance’s rating plate are the
same as those provided by your home power supply.
A 6% fluctuation above or below rated voltage is
acceptable.
For operation using different voltages you should
use an autotransformer of suitable capacity.
The appliance’s plug and the wall socket are fully
compatible, without any need to use adaptors,
multiple plugs, etc. If this is not the case, the wall
socket should be replaced to make it compatible.
The appliance MUST be connected to an efficient earth or
ground tap.
The supply lead plug in fact incorporates a special earth
or ground contact for this purpose. If by any chance the
sockets of your domestic wiring system are not earthed,
the appliance must be connected to a separate earth or
ground wire by a qualified electrician, in accordance
with existing safety regulations.
The manufacturer declines to accept any liability if this
accident-prevention procedure is not followed.
This appliance complies with E.E.C. directive
no. 87/308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compa-
tibility Directive) and subsequent modifications.
Cleaning the appliance’s interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then drv thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.
Instructions for total built-in
Door reversibility
Right-hand opening
Remove the pins (P) and (P1).
Left-hand opening
Remove pins (P) from both sides and the door.
Remove the middle hinge (A) and refit it on the
opposite side. Refit the door and pin (P) on the left
side. Remove pin (P1) from the right side.
Housing’s dimensions
Height 1580 mm
Depth 550 mm
Width 560 mm
Fig. 1
D112
P
P1
A
P
P1