Filter
Top Products
2
0
With regard to the protection against overheating
of surrounding furniture surfaces this appliance
corresponds to type Y. This applianceor the built--
in cupboard for the appliance respectively may be
locatedwith the rear wall and one side walltowha-
tever high walls or furniture respectively and with
the other side to another appliance or furniture of
the same height as this appliance.
Hob installation
D Cut out the worktop with the cut--out size as sta-
ted. The toleranced sizes must not be exceeded..
Saw exactly at the marking line. Recommenda-
tion: Mark the cut--out with a steel needle.Cover--
glue the line in order to avoid splintering of the
coating when cutting.
D Clean the worktop in the cut--out section
D With tiled worktops the grooves within the contact
area of the cooking area must completely be filled
up with groove material.
D Then fasten the catch springs with screws in the
cut--out at the marked position. The distortion of
the springs serves as a stop on the worktop.
D With natural, artificial stone, or ceramic plates the
springs can be glued in with special adhesive
(synthetic resin, two--component adhesive, etc.)
D The cooking area is entered from the top into the
cut--out section, centered and firmly pressed on
until the springs will catch.
D Check the seal in the supporting frame for perfect
seating and gapless support. Please do not apply
further silicone sealing matter as this will compli-
cate the removal of the hob if servicing is neces-
sary.
1
2
R5
sealing
frame
ceramic glass plate
snap--in clamp
worktop