Filter
Top Products
12
Door Reversal
Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out this reversal go through the following
steps:
1.Remove screws (A) which secure the worktop (B)
on the back.
2. Lift the worktop (B) slightly, push it about 20 mm
towards the rear, and lift it off upwards.
3. Unscrew the door hinge (C) and screw it into place
on the opposite side.
4. Refit the worktop.
5. Gently lay the appliance on its back with the top
held away from the floor by 5-8 cm (2-3 inches) of
packing.
6. Remove the bottom door hinge (E), unscrew the
foot at the base (F) of the appliance and refit them
on the opposite side..
7. Unscrew the handle (D). Refit it on the opposite
side after having pushed in the plugs with a punch.
Cover the holes left open with the plugs contained
in the documentation pack.
When positioning the bottom hinge blade on the
reverse side, the securing screws will require a
degree of exersion when fitting.
It is therefore advisable to lubricate the screw
tips before starting this operation.
Important
After completion of the door reversal
operation, verify that the door gasket is sealing
onto the cabinet.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket or accelerate this process by
heating up the part involved with a normal
hairdryer on a low setting.
A
B
C