Filter
Top Products
19
removing it from the cabinet, slightly tilting both
doors. Do not forget to remove the plastic spacer
(b) under the hinge. (fig. 2)
5.Take off the refrigerator door by pulling it slightly
downwards.
6.Take off the freezer door by pulling it slightly
upwards.
7. Unscrew the top door hinge pin (d) of the
refrigerator then screw it back on the other side.
(fig. 1)
8.Remove the insert of the plinth (e) by a
screwdriver. (fig. 4)
9.Unmount the lower hinge pin (f) and its washer (h)
and mount them on the other side. (fig. 4)
10. Replace the insert of the plinth (e) on the other
side.
11. Remove the covering nails (3 pieces) (n,k) of the
double door holder on the left side and put them
to the other side. (fig. 2)
12. Remove the (t, z) plugs from both doors. (fig. 3)
13. Remove the (u, v) door closing devices by
unscrewing the (s) screw.
14. Replace the (u, v) door devices on the opposite
side of the other door after turning them, then fix
them by screwing the (s) screw.
15. Replace the (t, z) plugs on the opposite side.
16. Fit the pin of the double door hinge (m) into the left
hole of the freezer door. (fig. 2)
17. Fit the freezer door to the lower door hinge pin (f).
(fig. 4)
18. Fit the refrigerator door to the upper door hinge
pin (d) then slightly tilting both doors fit the pin of
the double door hinge (m) into the left hole of the
refrigerator door.
19. Opening both doors fix the double door hinge
onto the left side using the screws (2 pieces) (c).
Do not forget to replace the plastic spacer (b)
under the hinge. Be careful that the door edges
are parallel with the edge of the mantle.
20.Put over the handles (r) on the other side and put
the plastic covering pins (p) supplied in the plastic
bag of this instruction book into the vacant holes.
(fig. 5)
21. Put the appliance to its place, ensure it is level,
and connect it to the mains supply.
In case you do not want to perform the procedures
above, call the nearest Service Force Centre.
Technicians will make a charge for door reversal.
Important
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket or accelerate
this process by heating the part involved with a normal
hairdryer on a low setting.
fig. 2.
fig. 3.
fig. 4.
fig. 5.